Collection: Accessories

The accessories here connect, extend, and protect the electronics already installed on your boat, covering systems from Garmin, Raymarine, Navico, FLIR Systems, Sensar Marine, and Iris Innovations. Much of the selection focuses on cabling and signal routing: extension cables for Garmin LiveScope 2 transducers come in short and long runs, so measure the distance from your transducer to your display before ordering. Adapters such as the Navico M12 to RJ45 bridge different network connector standards, while the Iris IP to HDMI re-coder lets you route camera feeds to a standard display input. For FLIR camera systems, the JCU3 joystick adds hands-on pan and tilt control via a Raymarine RayNet network connection, so confirm your network type matches before purchase.

Instrument protection and mounting hardware round out the category. Garmin GMI 40 covers and trim pieces are model-specific, so double-check the instrument series before adding them to your cart. Sensar bilge extension cables address sensor placement challenges below deck, and Garmin bulkhead connector kits handle clean through-hull wiring for scanning transducer installations. When shopping, the most important checks are connector type, cable length, and the exact model of the primary instrument or transducer the accessory is designed to work with.